Either update the name in the sensor's settings or delete the sensor and run a new auto-discovery with the template. If a VPN Tunnel is renamed, the corresponding sensor will fail.You can also use the Auto-Discovery schedule for this. When more VPN Tunnels are created, re-run the discovery to monitor these.SNMP must be enabled and the device must support the CHECKPOINT-MIB.Because the device template relies on the auto-discovery process, the device you want to monitor needs to be reachable via PING.The sensors implement default alerts whenever possible, but you can still fine-tune most channels by defining additional limits in the sensor channels settings or modifying the lookups included by default. The device template creates the available and compatible sensors based on the data at hand. The sensors can monitor the following if the data is available: You can use the device template that we provide below to automatically create custom sensors with the PRTG auto-discovery. Adding Custom Sensors using the Auto-Discovery + Template While PRTG provides a couple of sensors that work with Check Point firewalls by default, for example the SNMP Traffic sensor and the SNMP System Uptime sensor, you may be looking for more detailed and specific metrics/sensors. This article applies to PRTG Network Monitor 16.3.25 or later Monitoring Check Point Firewalls
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |